Short, Fat, and Fun (description approved by Quest!) The short length of this rocket makes it only flyable on A size engines. If you fly it with a B or C, then you will need to add nose weight (not included). Features balsa fins and streamer recovery.
Quest Skill Level 1 beginner modeler kits may require a little measuring, gluing, sanding and painting. Assembly usually takes 45 to 90 minutes. Drying time for glue and painting could take up to 3 hours.
This kit requires assembly. Hobby glues, finishing supplies, building tools, launch system and rocket motors for launching are not included.
Launch supplies sold separately. Requires Complete Launch System (Q7700), Quest Q-Jet™ rocket motors with FirstFire Micro™ Initiators and Recovery Wadding. One 9-volt, snap-top, Lithium battery is required for the Q2 Launch Controller - Not Included.
Recommended for ages 10 to adult. Direct adult supervision is suggested for those under 12 years of age when building or flying model rockets.
This package contains the Lift-Off Launch Pad and the Q2 Controller together for a great savings to the rocketeer!
The Quest Lift-Off Launch Pad features a 36-inch (91cm) two-piece launch rod,...
This kit requires assembly. Hobby glues, finishing supplies, building tools, launch system and rocket motors for launching are not included.
Launch supplies sold separately. Requires Complete...
Quest Skill Level 1 beginner modeler kits may require a little measuring, gluing, sanding and painting. Assembly usually takes 45 to 90 minutes. Drying time for glue and painting could take up to 3...
We can't think of many other ways that you can send an egg sailing 400 feet into the air and return it safely to Earth (and in time for breakfast!) The specially designed nose capsule comes...
Fun-to-fly and easy-to-build. This cone shaped rocket is perfect for small flying areas. Great for 'drag races' or spot landing contests. No Wadding Required with gentle tumble recovery. This kit...
This rocket was designed by internationally famous designer Scott Branche.
Enerjet Skill Level 4 master modeler kits require expert skills in model rocket construction and finishing. The...
The Quest Payloader One model rocket kit is one of three Quest model rockets to use TTW Through-The-Wall balsa fin attachment. There are three precise pre-cut slots in the body tube that allow for...
Quest Skill Level 1 beginner modeler kits may require a little measuring, gluing, sanding and painting. Assembly usually takes 45 to 90 minutes. Drying time for glue and painting could take up to 3...
Quest Level 2 experienced modeler kits require some basic beginner skills in model rocketry construction and finishing. Assembly, finishing and glue drying time can take a day or more.
This kit...
Short, Fat, and Fun (description approved by Quest!) The short length of this rocket makes it only flyable on A size engines. If you fly it with a B or C, then you will need to add nose weight (not included). Features balsa fins and streamer recovery.
error Your review appreciation cannot be sent